All Steam Ahead 2021 – Mad Hatter Preparations Part 4

 All Steam Ahead 2021 – Mad Hatter Preparations Part 4

An easy blog this week if a bit wordy.

Add Glue

 

If you remember I said previously that when putting on the base layer a lot of Glue residue had come through. I have managed to cover most of it with the Cogs.

However there was still a considerable amount on the Brim. Therefore I am going to cover it with Ribbon. So I added Glue to the Brim bit by bit.

Cut and Curve

 

Adding the Ribbon was not as simple as it seems. Straight Lines have a tendency not to like going around Curves. The part of the Ribbon on top of the Brim was Fine but I have to Cut and Curve the Underneath bit by bit.

Add Badge

 

Now I do have to confess that I did not make the Badge. I’m not that clever! It was something that I got off my friend Laura.

I wanted to change the Shape of the Hat which isn’t an easy thing to do without making a mess of it. I wanted it to look more like a Ladies Riding Hat of Yesteryear. I had the idea of Sewing the Brim to one Side (after Laura had talked me out of both sides saying Steampunk is not symmetrical).

I bent up the Brim, held it and put through a few tacking stitches to hold it in place. I then positioned the Badge and Sewed that in Place. A little bit of Trimming on the Ribbon and it was all done.