Mademoiselle Marionette’s Crimson Christmas 2019 Part 2

Mademoiselle Marionette’s Crimson Christmas 2019 Part 2

I am now going to move on to the Bottom half of the Gown

Pin Markers

First of all I need to Mark out what I am going to do. I did this by placing Pins in the Material.

Pin and Cut

I am making the Gown Bottom Open in Sections. Therefore I need to Make 4 Slits.

Part Hemmed

In the photograph above you can see that I have Part Hemmed the Bottom.

Gown Press Studs

Once all the Bottom has been cut and Hemmed I can now add the Press Studs. I want 2 Press Studs. One at the Top and One at the Middle of the Gown.

Press Stud Doll

In this photograph you can see that the Gown has been Press Studded up the Front. The Ribbon is around the Rough Doll’s Neck. Obviously it will Fall better on the Marionette.

Gown On Doll

Here is a different view of the Rough Doll. In this photograph you can see the way the Bottom of the Gown Splits. I have made the Gown like this so the Marionette can move her Legs easily.

The Marionette’s Arms are not impeded as the Band will go around its Chest and there is no Shoulder Material.

Mademoiselle Marionette’s Crimson Christmas 2019

Mademoiselle Marionette’s Crimson Christmas 2019

Apologies - this should have been posted prior to the Hurley Burley Blog.

One thing that Mademoiselle Marionette does not have at present is some Evening Gowns. I am about to correct that.

Crimson Material

I wanted something Festive and found some Crimson Sequin Material with a Sparkly Band

Which Way Up

After much deliberation I decided that I would swap the Material around so I had the Band at the Top of the Gown.

Hemmed

I then Hemmed the Material on Three Sides. This is because I knew what I was going to do with the Top but not sure what I was going to do at the Bottom. I did trim the Bottom though.

Ribbon

I wanted Crimson Ribbon but couldn’t find any so I sent Boyfriend off to the Market to find some bless him. He came back with exactly what I wanted so I placed it on the Material and Measured the Length.

Ribbon Hemmed

The Length was important as I was going to use the Ribbon to make a Cross Over. Therefore it had to be long enough to Cross Over the Chest area. Then it had to go around the Neck and have enough to tie.

Once I was satisfied that I had enough Ribbon to do this I cut it and Hemmed both Ends. I then Folded the Material over the Ribbon and Hemmed it securely.