A Comfy
Candy Christmas 2019 Part 3
The Glue has dried and I can now continue
Warning
I Unpin the material now the Glue has set. Warning! Don’t
be an idiot like I was. When I lifted the Foam I found because I had laid it on
the board to dry Glue down it had gone through. I was very fortunate that I
didn’t stick it to the board itself.
Check
your Pins
Continuing with doing things wrong check your Pins. Black
Pins don’t tend to show up very well on Black material. Incidentally I don’t
think I mentioned it but I spread the Glue using an old hair remover spreader.
Ensure
Pin Edge
For the next part I pulled the Edges as tight as I could
prior to Pinning.
Snip
and Glue
As I am working around a Curve I had to Snip the material
in order to pull it tight. Once it had dried I simply trimmed off the excess.
Overlap
Pin and Glue
The final task is to Fold, Glue and Pin the Overlap.
No comments:
Post a Comment