Autumn
Cape 2017 A Long Term Project Night Time Pocket Part 2
I will keep this blog quite short as it is basically
the same process as the Front Daytime Pocket
Night
Time Pictorial Chart Full
This is the full Pictorial Chart prior to the adding of
the pocket pattern
Measuring
Daytime Pocket Against Night Time Piece
Before I add the pattern to the Pictorial Chart I need
to work out roughly where the pocket should start. Therefore I thought the best
way to do this is to overlap the Fox Piece with the Badger piece. I could then
gauge where I think the pocket top would finish.
Mole
Pattern Transferred to Chart
Once satisfied that I knew where the pocket should
finish I put the Mole Pattern onto the Pictorial Chart. Then I proceeded to
pick up the 40 stitches and begin the pattern.
Mole
Pattern with Press Studs
After finally receiving the press studs I ordered I was
able to add them to the Mole Pocket. I then folded the bottom of the pocket
then proceeded to sew up the sides.
It was then to my annoyance I discovered that I had
sewn one of the press studs wrong. I had inadvertently put one bottom press
stud in one corner and the top one in another.
So before I could carry on with the flap I had to
unpick and resew one of the press studs.
Mole
Pocket Flap
Even though this was the second Flap I had made I found
it extremely difficult to position. This may be in some part due to the fact
that this time I was using five instead of the previous four leaves.
The problem was trying to make sure that I had covered
the Mole whilst not obscuring the feet of the Badger above. It took a good 2
hours before I was happy with the result and able to sew the leaves together.
After that it was merely a case of attaching the Flap
to the Badger Front Piece. Then I was able to sew on the final two halves of
the press studs.
Mole
Pocket Finished
No you haven’t gone mad. I rearranged the photo order
so you could see the Mole with its fine details better. Phew another blog
finished.
No comments:
Post a Comment