Out of Zone Accessories 2020 Part 2

 Out of Zone Accessories 2020 Part 2

My next challenge was to make a Necklace to go with the Earrings.

Reconstruct Chain

 

The first part was to Reconstruct a Chain. I found various bits of Chain and Clasp and put them together. I did have enough Copper Wire to make a whole Chain but thought it would be too scratchy around my Neck.

Add Copper Wire

 

At the End of the Reconstructed Chain I added the Copper Wire. I slipped it through the Chain and then Twisted it Back upon itself to secure. I am doing both sides simultaneously.

Washer and Ring

Using the same technique as the Earrings I added first a Washer then an Eyelet Ring I am trying to use the same types of materials that I have used before on the Earrings and Mask.

Three wires

 

After the Eyelet Rings I Looped both Copper Wires through an Embellished Ring. I still had lots of Length left on my Wires so I then Folded them back and Looped through the Eyelet Ring

Once I had done this I Looped them back through the Embellished Ring. Then I secured the Copper Ends. This gave Three Wires between the two Rings.

Two Wires

 

 

To finish off I decided to add a smaller Length of Copper Wire between the Eyelet Ring and the Washer. After Securing I then stretched the Wires.

So there you have it. A Necklace with a Single, Double then Triple wire effect.